ZY1207 7A No-Bus POL Data Sheet
3V to 14V Input ? 0.5V to 5.5V Output
8.
8.1
Pin and Feature Description
VLDO, Low Voltage Dropout
fault occurs. Pulling low the OK input by an external
circuitry turns off the POL converter.
8.10 SYNC, Frequency Synchronization Line
The input of the internal linear regulator. V VLDO
always needs to be greater than 4.75V for normal
operation of the POL converter.
8.2 IM, Interleave Mode
The input with the internal pull-up resistor. When the
pin is left floating, the phase lag of the POL converter
is set by INTL2…INTL4 pins. If the pin is pulled low,
the phase lag is set to 0°. Pulling all INTL pins and
the IM pin low configures a POL converter as a
master. The master determines the clock on the
SYNC line.
The bidirectional input/output with the internal pull-up
resistor. If the POL converter is configured as a
master, the SYNC line propagates clock to other
POL converters. If the POL converter is configured
as a slave, the internal clock recovery circuit
synchronizes the POL converter to the clock of the
SYNC line.
8.11 PG, Power Good
The open drain input/output with the internal pull-up
resistor. The pin is pulled low by the POL converter,
if the output voltage is outside of the window defined
8.3
TEMP, Temperature Measurement
by the Power Good High and Low thresholds.
The voltage output of the internal temperature
sensor measuring junction temperature of the
controller IC. Voltage range from 0 to 2V
corresponds to the temperature range from -50°C to
150°C.
Note : See the No-Bus Application Note for recommendations on
PG deglitching.
8.12 TRIM, Output Voltage Trim
The input of the TRIM comparator for the output
voltage programming.
8.4
ENP, Enable Polarity
The input with the internal pull-up resistor. When the
ENP pin is pulled low, the control logic of the EN
input is inverted.
The output voltage can be programmed by a single
resistor connected between VREF and TRIM pins.
Resistance of the trim resistor can be determined
from the equation below:
8.5
DELAY, Power-Up Delay
The input of the POR circuit with the internal pull-up
resistor. By connecting a capacitor between the pin
and PGND the power-up delay can be programmed.
R TRIM ?
20 ? ( 5 . 5 ? V OUT )
V OUT
, kOhms
8.6
CCA[0:2], Compensation Coefficient
where V OUT is the desired output voltage in Volts.
Address
Inputs with internal pull-ups to select one of 7 sets of
digital filter coefficients optimized for various
application conditions.
8.7 VREF, Voltage Reference
The output of the 2V internal voltage reference that
is used to program the output voltage of the POL
converter.
8.8 EN, Enable
The input with the internal pull-up resistor. The POL
converter is turned off, when the pin is pulled low
(see ENP to inverse logic of the Enable function).
If the R TRIM is open or the TRIM pin is shorted to
PGND, the V OUT =0.5V.
8.13 CS, Current Share/Sense Bus
The open drain digital input/output with the internal
pull-up resistor. The duty cycle of the digital signal is
proportional to the output current of the POL
converter. External capacitive loading of the pin
shall be avoided.
8.14 INTL[2:4], Interleave Bits
Inputs with internal pull-up resistors. The encoded
number determines the phase lag of the POL
converter when the IM pin is left floating. The phase
8.9
OK, Fault Status
lag is equal to the number multiplied by 45°.
The open drain input/output with the internal pull-up
resistor. The POL converter pulls its OK pin low, if a
ZD-00697 Rev. 1.9, 24-Jun-10
www.power-one.com
Page 14 of 18
相关PDF资料
ZY2105G PROGBL CONVERT DC-DC 5A OUT THRU
ZY2110G PROGBL CONVERT DC-DC 10A OUT THU
ZY2140G PROGBL CONVERT DC-DC 40A OUT THU
ZY2160G-R1 PROGBL CONVERT DC-DC 60A OUT THU
ZY7007LG-T2 PROGBL CONV DC-DC 7A OUT SMD
ZY7015LG-T2 PROGBL CONV DC-DC 15A OUT SMD
ZY7115LG-T2 PROGBL CONV DC-DC 15A OUT SMD
ZY8105G-R1 PROGBL CONVERT DC-DC 5A OUT THRU
相关代理商/技术参数
ZY1207L 制造商:Power-One 功能描述:- Bulk
ZY1207LG 制造商:Power-One 功能描述:HAZMAT - Bulk
ZY1207-T3 制造商:Power-One 功能描述:ZY1207 Series Single Output 0.5V to 5.5V 7 A DC/DC Power Supply Module
ZY120B 制造商:DIOTEC 制造商全称:Diotec Semiconductor 功能描述:Silicon Power Z-Diodes (non-planar technology)
ZY120GP 制造商:未知厂家 制造商全称:未知厂家 功能描述:2 W Glass Passivated Zener Diode
ZY12B 制造商:DIOTEC 制造商全称:Diotec Semiconductor 功能描述:Silicon Power Z-Diodes (non-planar technology)
ZY12GP 制造商:未知厂家 制造商全称:未知厂家 功能描述:2 W Glass Passivated Zener Diode
ZY12V 制造商:CDIL 制造商全称:Continental Device India Limited 功能描述:SILICON GLASS PASSIVATED 2.0 WATT ZENER DIODES